Why ripv2

Some of these enhanced features include:. Both versions of RIP share the following features and limitations:. Key points:. Unlike some other routing protocols, RIP doesn't use any kind of autonomous system numbers to identify areas of the network that are under a single administrative domain. Here's an example:. To do so, enter the ver 2 command at the config-router prompt. The most common network administrator's task is to specify which networks RIP will advertise and listen on.

You can define this using the network command. The If you would prefer not to send out advertisements on an interface, use the passive interface command. After you've configured RIP, you need to know how to check its status.

Here's a list of some common RIP commands. While this command shows the entire routing table, you can use it to see which RIP routes are in the routing table with the show ip route r command. Writing code in comment? Please use ide.

Load Comments. What's New. Most popular in Computer Networks. Most visited in Difference Between. The "network" command is used to specify the directly connected subnets on the router to be configured and that are intended to be included in the routing updates.

According to the classful, network specified, the subnets of that network are automatically identified and participate in the routing update. By default routing updates are summarized at network boundaries. In RIPv2 this auto summarization behavior can be turned off using the "no auto-summary" command.

Moreover, manual summarization can be configured on a per interface level. FastEthernet0 2 2. FastEthernet1 2 2. Loopback0 2 2. Vlan1 2 2. Gateway Distance Last Update. Routing Information Protocol:Cisco docs.

Buy or Renew. Find A Community. Cisco Community. Join us in congratulating October's Spotlight Award Winners!